Hot Rods 1947-54 Chevy truck inner fender attachment holes...

Like many I'm sure who have restored this type of truck's cab, the toe boards (below the firewall) had to be replaced... I did this on mine but in the process "lost" where the three attachment holes were located for the inner fenders to toe board on both sides...

If anyone is in the process of doing this, could you locate these holes for me with a few measurements?

It would be much appreciated.

 

...if your front sheetmetal is off, mount the core support, then the inner fenders to them, you can then tell where those rear holes need to be...

 

I have a 54 in the shop now that retains all its original metal. The cab is bare at the moment so it will be easy to get at. I’ll look at it tomorrow and see if I can get you some dimensions.

 

That would be great... Even a picture with a ruler taped close to the holes, I may be able to extrapolate the dimensions.

Thank you for your help.

 

Hope you can make heads or tails of these.

 

Those pictures with dimensions are ABSOLUTELY PERFECT...

Could I impose on your good nature by asking the same for the p***enger side holes... I believe they are different because there isn't a bracket on the p***enger side..

Thank you so much for this.

My52Chebby

 

Yessir. I’ll see what I can do here in a bit.

 

Had to take a little different approach but these should be pretty close.