Projects Big daddy's 1960 El Camino

Are you positive that your Spinchter Valve isn't stuck?

 

No sir, but I'll get it checked

 

So is this doing it when the secondary's just open or after they have been open?

 

In all seriousness, what does it do with a heavier spring?

 

After they're open

 

It did the same thing with the purple spring, that's why I put the lighter one in it, figured as long as it doesn't bog down on the hit its good right? There's no bog. Only issue is when it hits that 5000 mark. Maybe it just is what it's gonna be and I'll just use that as the Rev limiter lmao

 

Maybe a jet change up or down if we can determine if it's going to rich or to lean.

 

You better just call the Petronix hot line. They have all the answers.

 

And on another note I had a pop when I turned the wheel, one of the guys i work with climbed under it while I turned the wheel and said it's the leaf springs. So I came home this morning and made these. Is this acceptable? It fixed the pop lol

 

The secondaries has the stock metering plate in it. I've got a quick fuel plate that i can stick in it that uses jets in the rear. Iirc i put 72's in the primary

 

This is a pertronix flame thrower coil, but the distributor is the $239 speedway selection lol. If I had a rotor ****on, cap, and wires I'd put the point setup in it. I don't have much time between a body shop, an upholstery shop, and a fire department job to get much done before Saturday though.

 

When it’s over get yourself an iron points distributor.

 

I remember you having gel problem with the carburetor, did the metering plate get cleaned good?

 

Well the plan for my new points setup is to go in the big block

 

Yeah I think so myself. I cleaned everything with brake kleen and blew it all out. Used a tip cleaner on everything I could. Wonder if a little seafoam would do it any good?

 

Good place to store secondary springs

 

Buddy Christ!

 

Might also save the little fella if he falls off the dash and lands on his head!

 

Found an article on strengthening exercises for your **** sphincter valve. Be glad to send it to you if you think it will help .

 

No wonder. PTSD has him thinking…

 

Yes. The weights were so worn out that they were climbing over each other. It's got this in it now.

 

Drove it up to the machine shop to hang out a few minutes, Jamie said to fire it up tonight and see if I can see any fire jumping from the coil.

 

Coil wire is the wrong color

 

No sir it's not the points setup. It's an aftermarket speedway distributor

 

I knew it! I'll paint it and try that

 

Wait!!!!!

I think I have an old set of yellow wires, you’d then be color coordinated!

 

Thinking about it, somewhere I have a “normal” looking yellow coil too. If you act now on this limited time offer, you’d fit right in with all the cool kids.

PS

-no guarantee that anything I have will work or fit for your application, additional charges may be incurred. This is not an endor*****t or remedy for any medical condition, some inclusions may apply. Use at your own risk-

 

I told you to stop drinking the bong water brother!! That **** will rot your brain cells