Hot Rods 400SBC BUILD

All,
I am needing some help deciding on heads and possibly a different cam for my 400sbc. This was a healthy rebuild that has less than 10’000 miles on it. Problem is it’s been on an engine stand for 10+yrs and hasn’t been running in a vehicle for probably 20yrs. What little I know of the motor is it’s bored .040 over and had a decent cam in it, the heads are stock, with an edelbrock performer intake. Goals are to wake it up some with a good set of heads, possibly a matching cam, and carb cfm recommendations. I wish I knew more on the specs of the current camshaft that is in it but I just don’t. I know it had a healthy lope to it at idle and great low end torque but that’s all I know on it. Hope y’all can offer some great advice!
TIA!

 

Brodex Dart AFR 200 or more 23 or 18 degree , 400 plus like air & single plain intake or a ram,

 

Thank you for the tip! Sounds like much of what I’ve read. Nice to have that re***ured

 

more info is needed but you will not go wrong with 200 ,, cam in .540 lift plus with hydraulic roller, Solid roller on street Need good lifters in $800 plus (good $1,600) range & really same applies to hydraulic rollers

 

Appreciate it. I’ll take note to that while shopping!