Technical Blower snout length on a SBC

What does the front of that intake look like, only have seen the back?

 

I think you are referring to the OP’s manifold, here’s the front of the Edelbrock B10.

 

Thank you. Looks like a race manifold. The OP should look for a different one if it's going on a street ride.

 

I run a Weiand, the early one with no water crossover. I drilled the heads for 3/8 pipe and ran -10 lines to an Offenhauser thermostat housing, never a problem with cooling.

 

Run a BDS and not have to drill the heads.

 

If your heads are aluminum you can weld an AN bung to that spot

 

This one is only $4500, but it's wrong on so many levels for street. But it would look cool, at least it has that going for it....