Technical Ball Joint Installer use on Wheel Studs?

looking at the size of the tool, it might fit between the shoes at the bottom...

only one way to find out. Or, a couple ways. If you buy the one at a parts store and return it, you don't end up paying anything.

 

It’s Jungle Prime! Returns are not an issue.

 

My self have used
Roller bearing with nut
Washer's grease nut
Torsion washer ? ( needle bearings in between washers ) with nut .
Air hammer
Ball joint tool
Heat
Press
Hammer
Whatever it takes to get the job done!!

& I use these hollow Diamond hole saw
To remove "" Swedged"" studs , they cut real well , like $10

 

Never been a problem , little strategic lubrication..