Hot Rods THE INDUCTION THREAD

No just some I seen on Facebook for sale.

 

What's up with the fuel inlet on these AFBs never seen this before.

 

not sure James but I can tell you that they are on a FE ford intake they seem do everything a bit different and probly will fail as FE stands for failure every time lmao

 

Your not giving Nathan much hope.

 

@saltflats that enderle barn door for a 4-71 is a rare piece I’ve only seen one in the last 30 years unlike the 6-71 style I’ve seen hundreds to run one of those units you needed one helluva engine under it the amount of airflow is almost too much even the hilborn units are a lot but manageable and all of the new EFI stuff can’t sustain that much airflow they have smaller butterflies and throttle bores even though they are awesome and I would love to have one I could never afford and engine that could use that much airflow lol

 

https://www.hotrod.com/features/welcome-black-carter-november-1983-982-1220-44-1/

 

Good low end?

 

wish that ignition wasn't so blurry-would like to see it

 

I think that is a Wico that was modified and adapted to the flathead by George Pounden. Pounden used Wicos magnetos and later produced his own too.

 

thank you!!--was thinking it was,cuz of the cap and that high tension wire..-about the only things not blurred out

 

Those cast belcranks are bitchin!

 

1000007430 by 55 gasser pickup posted Apr 6, 2025 at 5:15 PM

1000007431 by 55 gasser pickup posted Apr 6, 2025 at 5:15 PM

 

LOTS of adjustment in that linkage!!

 

Doesn't look well thought out.

 

I put a little thought into mine. I ran this on my 360 inch small block Chevy in my 65 Chevelle. I sold it later at a swap meet and maybe a year or so later I seen it on this truck in a car show.

 

Doesn't look the same. My bad different direction....

 

looks the same to me
it'd be easier to compare if both views were of the same end

 

It for sure is the same one. That project was my first time running a vertical mill and tig welding aluminum. It was built using a crossfire lower intake. I collected over 25 carburetors to come up with 4 the same.

 

That sounds like a Rockabilly band!

“The Bitchin Bellcranks”

 

Yes they are, anyone have info on where a guy might get some? I'd have to throw my fabricated ones in the junk!

Denny, do you think someone may have cut those out of plate and made them look like castings?




Yes they are, anyone have info on where a guy might get some? I'd have to throw my fabricated ones in the junk!