Technical Need pic of a 371 Blower on a Flathead Ford?????

Anyone have a pic of what parts are needed to run a 371 Blower on a late Ford flat head? Preferably with grooved pully's. Thanks!

 

Probably a home made base attached to an intake made for carbs, and a really long snout out front. Custom pulleys for all?

 

Thats what I am looking for!

 

Here is what I have done for the next project: made a blower manifold from an ordinary single manifold. Lots of welding but costs almost nothing. Will make a snout and rear bearing plate when time allows.

 

Are you going to prune it and flip it over?

 

Cropping/pruning yes, didn't know I could flip it! Why flip?

 

Intake No big deal to make ,

Thought & different on Snout
Needs to be 10-12 inch long if mounted direct to blower ,, me a 1 inch or 2 inch belt ,
But I think out side box , I think I would make a Two ,,
Crank to Pulley belt
Then a Axle , back side a pulley
Then a short belt from axle pulley
Cross to pulley on blower
Front .
So 2 belt
4 pulleys
Or mount case backwards
Same set up with belts

 

I don't know. This one was upside down, notice the casting number, which is usually on the bottom, is now on the top.