Featured Hot Rods 35/37 ford truck chassis thread

Thanks so much,now I have a better idea on how to do it.
I ***ume when I tack the mounts for the split bone sand mock the axle in possition,ill have a better idea on how long the new spring will need to be,also I'll have to heat and bend the perch mounts.
Here's another idea

 

Be aware of your caster when you are making wishbone mounts and possible crossmember changes.

 

Yessir.
And so it starts

What Is the name of that gasket between the trans and torque tube? Thanks

 

Any reason why they would notch this ?

 

I have these sets of pedals..the one with the big box bracket came from my 1940 dodge monteplier,,it would be so cool to use it with all the linkages and stuff

 

Easy way to put in a svivrola engine in it.

 

You can use the '37 pedals and fabricate a master cyl mount like V/8 Garage does.
Little bit of metal and hardware; low cost and easy.

'39 pedals fit with a little trim to X member opening. Clutch linkage matches and it has a master cylinder mount. '39 pedals usually cost $$ tho.

'40 pedals work too; but you need to add the Z bar and change the throw out shaft. '40 pedals don't cost much; but more work involved.

 

This is why people build street rods or just do frame swaps..
**** all this old ****!

 

Those old things drill out pretty easily.

 

Heat
PB blaster
Hammer
Patience

 

You want a cool car, you have to earn it. Or if you want easy you could go hang out with the Camaro guys.

 

Come on man, your making progress....

 

Had a very frustrating Saturday night early Sunday..I had to cut the axle to cut the perch bolt..its out...the cherry on top was that i missed a swing with the 15lb BFH and I hit my shin,im lucky to be walking..
I ordered a 39 break ***embly from a hammer and tomorrow i will order the boling bros rear hydraulic brake set,
Today i finished breaking both axles down and flattening the rear crossmember the way @Marty Strode showed in one of his Tech articles...
Good thing about this frame,everything came apart pretty easy,except those ****ing perch bolts!!
I pulled the extra parts i had laying around...I just gotta read read read,and get ypur guys help to set the front suspension.

Except we stick weld up in this muddafugga!!
Tomorrow ill flip the frame over and weld the inside..