O/T 70 cuda spec.? Anyone

I know this is O/T but I figured I'd give it a shot. I am doing some resto work on a 1970 plymouth cuda. I need to know the distance apart the rear leafs should be at the axle pads. Either pin centers or inside to inside once ***embled. Something ain't right in this car and I need to figure it out asap. I know someone on here has one of these cars or knows of a good mopar website. Any help is appreciated. Thanks, Mike.

 

Allpar.com I think is a good Mopar Forum

 

I don't have the spec but I do remember the springs don't set paralell with the frame. Hope that helps. best of luck.

 

they taper in from the front...Like a shallow "v"

The pins aren't centered in the springs, either. they sit about 1/3 down from the front bushings.

 

GO over to Cuda-Challenger.com or I can give you the spec's on Saturday.

Regards,

Steve

 

46" pin to pin.....

http://www.bigblockdart.com/techpages/diffchart.shtml

 

You got your answer, but just in case:
www.moparts.com

 

that looks like the answer 46" center to center

 

Thanks guys. I really appreciate the help. Guess I gotta cut off the pads. They are 44". They were just done by another shop "to factory specs." Guess they got the specs. from the wrong "factory".
I knew they tapered in towards the front and that there was a left and right. Now I just gotta pull it all out and start over.