Features Good or bad let us see pictures of your F1 or F100!!!!

Found this one on ebay today nice!

 

Lets talk camaro clips and chevy 5 on 5 pickup rear ends. Has anyone ever put this combo under there 53 to 56. Is the pickup rear end to wide. Can you make the 5 on 5 pickup rotors go on camaro spindals. The reason I ask is I already have a camaro clip under my 56. I would like to have a 5 on 5 pre 88 chevy pickup bolt pattern with out using a wheel adopter. The other reason I ask is I already have a lot of chevy pickup parts. Thanks for any help

 

I dig it!

 

I have a Trans Am clip on my 56,same as Camaro. I used Oldsmobile Custom Cruiser spindles direct swap and 5 on 5 bolt pattern.

 

I am no GM expert (I leave that nonsense to my brother), but Impalas from 1971-76 seem to have a 5x5 pattern, as well as 2wd chevy trucks. The popular 57-72 Ford truck swap is 61.25", so anything close to that width should be good. The stock frame width for spring pads is 40" on center.
58" axle width is probably going to be too narrow, unless you tub the bed. Should give ya ballpark numbers anyhow.

 

This was my daily driver back in the 80's. It was a Canadian Mercury with a 71 Boss 351C and 81 twin I-beam suspension up front. Drove it 72,000 miles in 5 years.

http://thumb3.webshots.net/s/thumb1/5/77/43/73757743xDGbYf_th.jpg


<IMG" target="_blank"><IMG< a>

 

its last day as an original.

 

Before:


After:


$100 Cannabalized RUSTY parts-truck, trying to get it done for spring.

 

And since I've seen some bigger rollers and stuff posted:

 

here's a friends partial collection...

 

Here's My 53!

 

maybe this...friends collection from Swift Engineering...Ontario Ca.