Shaved Handles...what did You Do?

i think the little ****on mixed with the vent window idea incase of ****on failure.....cant wait till i finish!

Thanks All

 

im just reaching in until i get my side gl***. then i'll probably run some kinda cable into the engine compartment or trunk. or at least until i get tired of it

 

On my daily ive got an autoloc kit, which really isnt that expensive, lil over a hundred if i remember right, then on the p***enger side a stainless wire that runs to the inside of the bottom of the fender...for the oops, or **** my keyfob is inthere trick..then heres a cool trick to make the soleniods last longer, we went to walmart, got baby ******s for bottles and put them over the wire and top of the solenoid and walla....no more corrosion...

 

Search "door popper" on ebay.

 

I went the same way. As well as the trunk (hidden under the gas fill door)

 

Just because your to damn tight to buy the real deal. Hope your amking the best of a bad winter. O I used starter selinoids.
Don

 

Hey Dad, I resemble that remark. M J has said for years that the only time I would take her and the girls out to the state fair was on free day. I always thought that I was just being thrifty.
Besides that you probably had some one give you the solenoids.
Later,
****

 

Use the most simple way you can. I'm using remote electric windows controled by a Hotronics cpu. I just roll down the windows and reach inside. Never had a breakdown with it, but would never shave door handles again. Had shaved handles on my 56 Merc when I was a kid, had a dummy spot light that rotated and pulled a cable though the door hinge to release the latch. It's cheap and simple.

 

I did that vent wing thing for 18 years, got over it and put door handles on it when I finally painted it .