Hot Rods Hemi intake picture thread

Are you sure that's a Moon? If so they were probably made for Moon by MacKay who were also in Santa Fe Springs.

 

Yes I bought the car for Billy Wisharts ,cool guy ,Bitchen car
and the motor came out of a boat
also the Manifold says Moon on the side ,I will take a better picture
just looking for info about when they were built etc
I talked to a guy that had the same set up on a boat
said he has only seen 2 Billys old one(now mine) and his ???
Thanks

 

delete

 

No pic re-post please....

 

Here's a few:

 

... continued:







NOTE: The majority of these pics came from The37Kid's "354 392 HEMI Itakes" thread.

 

I don't have any good pictures of just the manifold ... but somewhere under those
four Stromberg 97's is a CRAGAR intake:


Circa 1958 ... on the 331ci. HEMI


Circa 1975 ... all polished up on the 392ci. HEMI

 

Cool stuff! Thanks for all those pics Hemi32!

 

Here's some pictures of the Blower intake I'm building for my 291 DeSoto. I traded a 250 pound, 291 cast iron 4bl intake for an aluminum Edmonds 291 2X2 intake. MUCH lighter, and better fuel distribution. Had to mill the carburetor pads parallel with the intake ports, and cut/paste the thermostat housing to point straight forward, to clear the intake top and drive belt. Just about done...

 

Very nice work, that little desoto will look awesome with that lung on top.

Any way to get larger openings into the plenum?

 

Not really...it's a dual plane intake, and there's not much more room on each of the pads to the sides. I will be rounding over the edges of the openings to help air flow a bit, but I'm counting on the blower to do most of the work...

 

That will run very nicely I'm sure.

 

Here's one and its for sell

 

Wow! This thread has matured nicely!

 

so your the guy who got that intake!! man i sent him a message but he said it was already gone! lucky you

 

Here is my Weiand 3x2 manifold. I was told that it is 1 of 75 ever made but don't really know.

 

Here's another Weiand. Bought this on e-bay about 6 years ago and it wasn't cheap!!

 

DeSoto, got a build thread on that?

 

edmunds 2x4 for early chrysler 51-53 with small intake ports
pretty rare per disscussion and more info here:
http://www.jalopyjournal.com/forum/showthread.php?t=338081&highlight=hemi

 

Here's some more intakes, courtesy of DE SOTO...

These are all Chrysler manifolds.

 

Thanks Scooter !

Anyone have any more feedback on those 2x4 Edmunds manifolds ?

 

Rare 1953 Bonhalite Pan Americana Race intake with 2041s carbs the other is a factory dual 2317s carbs wth the Ham Cans

 

couple of mine, hilborn injection and crager intake with a 671 and isky drive.

 

Kurtis with an A311 intake.

 

Hand built by Gene Adams....I was told.






See Also

http://www.jalopyjournal.com/forum/showthread.php?t=377205

 

That's pretty cool relic.

 

MORE! I need more!

 

Here is a Weiand for a Dodge Hemi 241..270.. I just finished this, wanted it ready for the Reno Swap Meet in Sacramento..