47 ford, new seats

New to the site and looking for any help on a floor board issue i'm having. I took out the bench seat of my 1947 ford and am putting in bucket seats, but the metal is so worn in looks like the seat will just fall right through where we drilled the new holes. Do I need to look into getting a new metal piece for just under the seat or can i reinforce it some other way? Any advice?

 

My advice is to do a proper intro, then post a new thread with your question

 

Ditto !

 

Ditto...but post a new thread on the main message board..not here in the intro forum page... Read the "Sticky" at the top of this page.