Y block flywheel difference

Hello guys, Im on the hunt for a y block flywheel and I had some questions maybe I can gt answered. Is the y block flywheel unique? Can I use a truck flywheel in a car? Thanks.

Sent from my DROID device using the TJJ mobile app

 

From what I understand they're all the same- and fit from early 54 y-blocks up to the newer 62's...

 

I'm also pretty sure they are all the same. If in doubt y-blocksforever.com

 

One for auto, one for stick. Pickup is the same as passenger, but F 6 may be heavier.

 

Alright Thanks guys I was a little iffi since I've never dealt with manual transmission flywheel . Thanks again

 

They will all physically bolt up to the crank but are drilled for different size pressure plates. Easy enough to have one redrilled if need be, but something to be aware of so you gather all the correct pieces.

 

I run the flywheel and 11 inch pressure plate from a F600
and a 11 inch disc with a 4spd rug no problem
the flywheel looks the same as a pass flywheel

 

How about if I have a t-bird bellhousing? Would a truck flywheel n pressure plate work? Because I am aware that the truck bellhousing is a little bigger! What would be the cause of that?

Sent from my DROID device using the TJJ mobile app

 

You should be fine

 

I have 54 flywheel on a 59ish 292 truck motor with T bird bell house connected to a later 50's od three speed w/a Tbird clutch.
I think you"ll be fine.

 

There you have it!! A combination of it all. Im sure your set up will be fine.

 

Be carefull, the flywheel from a 64 f100 with the large spline input 3 speed will not fit in a pass bell.