Register now to get rid of these ads!

Hot Rods Posy rear axle on the street?

Discussion in 'The Hokey Ass Message Board' started by Dirty Dug, Oct 26, 2012.

  1. Heo2
    Joined: Aug 9, 2011
    Posts: 660

    Heo2
    Member

    And one wheel burnouts welds the spidergears
    to the shaft and in the end the whole diff is
    toast
     
  2. Deuce Roadster
    Joined: Sep 8, 2002
    Posts: 9,519

    Deuce Roadster
    Member Emeritus

    If it is low priced :)
    I would buy the POSI 8 inch center section for no other reason than they are fairly rare. 9 inch Posi's are common ... the 8 inch ones are hard to find.

    Ford did not install many limited slip rears in the 8 inch Ford. Vehicles that got the 8 inch rear end were not considered
    " performance " vehicles.

    That said ... I have found a couple in Pinto cruising wagons. Factory installed :eek:
     
  3. Yes they are somewhat rare and as someone else said.... It's a hot rod....why not do it. Deuce do you figure the factory was anticipating V8s getting stuffed in the Pintos!
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.