Hello all. I'm from Dubuque,IA. I am a mechanical designer (Cadd drafter) for a day job. I am building a 1974 Honda CB360 Hardtail Bobber. Hope to have it done this spring. I enjoy all hot rods from "rat" rods to shiney trailer queens, to everything in between. I have recently picked up pinstriping. I have been doing it for about a month. Enjoying it everytime, and getting a little better everythin
Welcome to the HAMB from an Iowan Design Engineer. What cad system do you run? Carmak Riverside, Iowa
I would have guessed your images looked like Solidworks. I used ACAD full time about 15 years ago but since then I have run Pro-E/Creo. A coupld people here run Solidworks and love it. Do you have your whole bike modeled? Carmak
I used Pro-E in college, but haven't used it since. I have been using different cad programs from the last 13 years. Those were rendered in the Solidworks Photoview 360. I do not have the whole bike modeled, just the 2d side view. I have modeled various components that I am making for the bike.
Sweet bike, welcome to the board. Who is this? I'm from Dubuque, do you know Garrett? you guys should get together and stripe some ****, you're not too bad at it! Keep up the good work! I'm Tim Then. I have the car in my sig, check it out, im sure you've seen it
My name is Tim Buchholtz. I do not personally know Garrett, but i know a few people who know him. My co worker who is doing my welding is Andrew Courtney, not sure if you know him.. Thank you, I am trying to get better every time. Here is where my bike stands currently. I need a few things done yet, and then it is off for powder coat. Hopefully going to have it done by Torquefest. I got bored and striped my tank. Even though i'm going to have it powdercoated.
The Jalopy Journal
