Hot Rods 1931 plymouth coupe pictures

Started some of the repairs to the fender wells. Removed the bad steel and replaced it with a new inner fender assembly that I made out of a trailer fender for the radius part and flat steel for the back. Still need to install it, also repaired the floor and flange in this area. Joe

 

A few more pictures Joe

 

Looking good Joe, great to see you are making some progress. I know all about getting side tracked with other projects.....

 

A few more pictures of the fender wells

 

Great car. Dont let it sit too long.

 

Looks nice I will be watching this one.

 

Nice looking ride's Guy's. Always good to see something new.

 

Sweet build. Keep up the work we need time see more pics

 

I need someone who can help me with a pattern of the rear lower corner of a 1931 Plymouth coupe.1st photo is what I need and 2nd photo is what I got.

 

I would like some kind of pattern so I can see measure this area. I don't know how far down this should go. I could guess by the other photo; but I have heard of guys taking poster board and creasing it over the lines to give them a better than guess. there are three different styles of this rear corner section. The 30 U, the 1931 PA, and the 32 PA. maybe a 4th one because Oldblueoval calls his a 31PA but mine is different. I have been studying photos of these cars to try and get a better understanding of them.

 

Just as a little help, any 1931 Dodge DH6, DeSoto SA6 and Chrysler CM6 will be exactly the same. I could probably supply photos and dimensions.

 

How's progress on this. Later.

 

I have about the back 12" of a 31 up in the rafters I would sell if that would help. I can get pics if it will just stop snowing and warm up. What part of Okla. are you in?

 

North edge of Edmond, Okla. (North of OKC,OK area)

 

Thanks 31 Dodger.