Ford 200 6cyl Info Needed

I have a 200ci 6cyl in my Econoline. I believe it is a 1968 engine if I remember correctly. It has the intake "manifold" cast into the head. A few of the bosses with bolt holes cast into the head for the exhaust manifold are broken off. I'm looking for another head to have rebuilt so I can swap them out.

The hole in the intake for the carburetor measures 1.75" in diameter. I know some earlier 200's measured 1.5" here.

Does anyone know what year Ford switched to the 1.75" carb base opening and what years will interchange with mine?

Thanks, JH

 

You might try going over here and asking that question.

 

^^^ THIS

I looked into the small six heavily before deciding on a big six for my project but I can't help you any more than suggesting fordsix. I'm pretty sure you can fit a big six in there though

 

Or: http://cl***icinlines.com/HeadSwap.asp

 

A lot of good information about the "small" Ford six on this site..... LW

 

Didja get my P.M.?