The Jalopy Journal
Just wondering if it would bog down between shifts or something?
With all that matieral removed from the flywheel will it still be streetable? How light is too light for a pickup?
When you say "cut" do you mean you had the entire lip machine off? I'm leaning towards the 9in as I already have a new pressure plate and clutch...
Forgot to ask, will the 10 inch pressure plate fit in early top loader case?
I'm building a 59a engine for my 37 pickup running a 39 trans and 3.25 banjo. It will be bored and stroked to 286ci, edelbrock 4 barrel, edelbrock...
Actually I mis read the posting. It is a 3 5/16 bore so I believe that would make it about 296 ci. I was wondering about the rod angles as well....
I have a 59ab block sitting at the machine shop ready to be machined. Hasn't been bored yet but it's sitting at a .040 over right now. I was...
The wheelbase measures at 112 inches. Has the transverse leaf spring pack as well as overload parallel springs on the outside of the banjo. Tire...
Thanks for the reply. I believe it's on the original chassis. How would I know? Being that it was a stake truck does that mean it's a 1 ton or...
Hello all, Just recently picked up my first project. It's a 1937 ford stake truck with the 85 hp flathead. Got it for 300$ with almost everything...
Separate names with a comma.
The Jalopy Journal