The Jalopy Journal
None taken! Im an engine and chassis guy The chipper is like peening it to relieve stress correct? The Welding supply shop said the rods are 90%...
I recently picked up a complete 392 literally out of a barn laying in the dirt. I picked this up to put together a good little street motor to...
I hope this is posted in the correct forum......
Ok I hope there is a simple fix for this Issue. I am having an Issue with my Speedometer, it has a pulse generator at the old cable hookup. When...
Answer 1 the arms that come down and have the heim joint/turnbuckel assembly down to the rear end housing. The Arm itseft from the tube down to...
Here are some photos of when the car was in final assembly. some of the areas I have talked about can be seen here[ATTACH] [ATTACH] [ATTACH]
All the joints checked out fine, nothing binding as the car is parked after a ride. going to ditch the diagonal bar and go with panhard bar... see...
OoooK, Just spent some quality time on my back under the car trying to figure out the best way to get a panhard bar in there. A few dilemmas pop...
Thanks everyone for the input! general consensus just backed up my original thought put in a pan hard Bar. Going to be tricky but Ill make it...
Forgot. tomorrows "Agenda" is to break all the nut loose on the 4-bars to see if they all spin equally to check for Binding an any particular Bar.
Ok let me be detailed about this one. My T-bucket has a Parallel 4-link (Chris Alston Battle Cruser) setup. All big 3/4" Hiem Joints on the bars....
Separate names with a comma.
The Jalopy Journal