The Jalopy Journal
1961 Chrysler maybe?
Thanks for all the thoughts and ideas. Sounds like I'm not the only one that has run across this kind of problem before. I think that I'll mull...
I've got a good running '39 flathead that has developed a rust-through hole in the water jacket just below the lower bolt on the exhaust manifold,...
The '39 was owned by Jim Hicks in the early '60's. Not a lot of information on him or his car. However, I do remember reading a bit of history of...
As Charlie Chops says the item needs to be submerged in the vinegar to work. In my experience I've found that when the item is removed and dried,...
It looks like it may have taken a bit more work than just swapping front sheet metal. The windshield/cowl appears to be from a '39 (split...
A quick question regarding putting a SBC into my '39 coupe. It has stock running gear (but with the little 60hp tube front axle) and the stock...
I ran into this same kind of problem with my '39 Standard with the stock engine. The PO had installed a Honda (?) alternator on a homemade bracket...
Man! I can't believe that I'm the only old fart boozer here today. I never was really a fan of beer so went for the higher octane stuff, usually...
It seems like you've addressed most of the common causes for over heating. I had the same prob with a OT car several years ago. Seems that the...
I'm in San Jose. Please pm me about time, location, etc.
I ran into this problem and came across a solution on the HAMB board many years ago. when you've used the product and still have some material...
If what is left of my gray cells remembers right, I think that Lazzie (the Swede metal shaper) did this during one of his vacations in Sweden. He...
Separate names with a comma.
The Jalopy Journal