The Jalopy Journal
i picked up a manual trans and bellhousing, it is a a833/my6, it uses a special bolt pattern chevrolet bellhousing. i was told the ball stuck for...
Still have the 35 ford, sorry for not see this sooner
Yes, the new one line up ok, they move the engine back Sent from my SM-S367VL using The H.A.M.B. mobile app
I bought the one I think it was brothers truck for 6 cyl to v8 swap. Bolt up no drill etc... came with new mounts and all hardware. Did not know...
Here is a shot[ATTACH][ATTACH] Sent from my SM-S367VL using The H.A.M.B. mobile app
The center dump headers will definitely not work. Moved the engine back to the rear position, headers are setting on the a arm and very close to...
Thanks for all the help, I found a video on YouTube that confirms the forward holes are for 67 and later, the rear holes are for 60-66. You learn...
It may be. When I put the engine in the aftermarket mounts have 2 holes in top and 2 in bottom, I had it toward the back at first, only 1 hole...
I bought the aftermarket tube style mounts. The original was a 250 Sent from my SM-S367VL using The H.A.M.B. mobile app
It would move the engine back approximately 1.5 to 2 inches Sent from my SM-S367VL using The H.A.M.B. mobile app
If the engine were in the rear holes only 1 of the lower mount holes line up. Sent from my SM-S367VL using The H.A.M.B. mobile app
I have a 66 c10, I put a sbc in it,I had a set of headers on it but in the location the motor mounts bolted up, the passenger side header hits the...
Lowered 17,500 buy it drive it home, located east central Indiana Sent from my SM-S367VL using The H.A.M.B. mobile app
Separate names with a comma.
The Jalopy Journal