The Jalopy Journal
Nice looking motor, love the cream color. What can you tell us about the crossflow head in the photo? [ATTACH]
[IMG] [IMG] [IMG] [IMG] This ’32 Ford roadster pickup was built in 2021 at Johnson’s Hot Rod Shop of Gadsden, Alabama, using a steel reproduction...
Most enjoyable postings thanks
Thanks for the quick reply. Does it run well and accelerate well with these two carb's?
What size of Winfield's are you running?
If you are pulling the motor out you need to check the end play in the crankshaft. should be .002" If the flywheel housing was not dialed in so...
And some are still waiting for issues #84 and #85 to show up in the mailbox..........let alone #86
No; wooden mold, cope and drag with core for the internal runners.
I got it cast from permanent mold, also got single cast, to fit A through size D carbs.
When you set the position for the radius ball mounting, you should check the the castor angle is maintained to the original model A castor angle....
[ATTACH]
There are slots in the head of the bolts that are extending out of the bottom of the bellhousing. By removing the cotter key, the shaft in which...
Lingo head. 11 heads were produced. Searching on youtube John Lingo Ford model A. [MEDIA]
ford introduced the panhard bar in 1942. Cross steering in 1935.
yes 35 - 16" wires and lower the front end is a good start.
Separate names with a comma.
The Jalopy Journal