The Jalopy Journal
bump
I'm trying to put a Tach on my 51' Hudson, but I can't figure out what I need. The car is still running its original 6 volt positive ground...
I posted about clearing it the other day, and some people wanted some pictures so here you go...
I have a 1951 Hudson positive ground 6 volt. What I did to eliminate this problem was to run my own wiring harness. I ran a a wire off of my...
^ No I'll probably keep it to the day I die then leave it to be my kids problem
Thanks for the Help. But yeah I guess you could call me lazy for not wanting to fix rust, but it also doesn't matter when you have replacement...
I personally like the look of cleared patina, but I don't think that when you clear it you make it fake. I just want to clear it so it still looks...
Hi All, I'm going to start clear coating my 51 Hudson, but I have a few questions. How would I clear the paint trying to save all of its...
Extra re-enforcing rib where is it located? I'm just asking because I have a 262 that has an issue fitting a normal 262 head gasket.
yes that is correct the postive terminal has a strap to the frame, and also the same for the starter
I have to coil installed correctly, with the correct wiring. I gaped the point at its correct .020", and it does have the rotor on I actually...
on the coil side. How would I run the wires on the coil. I have a positive side and one side that says distributor. Would I hook this up opposite...
Separate names with a comma.
The Jalopy Journal
Post
