The Jalopy Journal
Your carb has a replacement throttle shaft and looks like new fasteners in the carb base. Someone has gone through it by the looks of it. I...
I'm reposting this because it was buried in the Quote when I posted it yesterday. As far as adding the B rear flange to an A pan I have looked at...
Same truck with 4.50 X 17 Excelsior bias-plys on the front and a reverse eye A spring in the rear with 4 leaves removed. Makes the 6.50 X 17...
I'm throwing this picture in here because it illustrates the suspension, wheel, and tire choices you list in Post #12, except this RPU uses a T...
Mike's Affordable sells a set of eight for 69.50 USD. I bought a set from Mac's a few years ago; they might still be available from Eckler's. I...
One of the best people that I have met in the Banger World, and the founder of the Northwood Iowa Flat Hill Climb where many of us have discovered...
Thanks for showing the photo with the gasket. The GEM head is new to me; any details you can share about it?
Be sure to fit a head gasket to that head before installing it. It looks to me like the flycuts are not symmetrical adjacent to the head bolt...
Definitely need the bolt to hold main shaft in proper location without end play. Synchro will not work properly if the main shaft is allowed to...
Order online and they are very responsive. I had a small issue with an error on a part shipped and handled it with e-mail. Charlie was very...
Based on the intake manifold that sure looks like a flathead setup. Also exhaust sure looks like a split manifold or an additional center outlet....
That's correct.
It's possible to disconnect the wishbone ball from the bottom of the bellhousing and use a 2 x 4 between the wishbone and oil pan to hold the...
Separate names with a comma.
The Jalopy Journal