The Jalopy Journal
[IMG]
And.......hopefully this will allow some movement on my journals
Already sanded one rod, is it to far gone?
Albemarle! How do ya do neighbor?
I'm going to pull another set that don't have enough play and check those, I'll take pics then
I was able to sand burr off smooth, to naked eye and feel, but was just questioning if in the process sanded he surrounding area far enough to be...
Deep gouges, this is what I'm afraid of
Thanks
No, not to this extent! Meaning I've tore down and reassembled stock engines but never had issues with damaging the chamfer of a rod, especially...
I'm no engine machinist by any means, this is my first "hot" engine build. I've never had to deal with perfecting a new build.
I am looking for advice because I am not sure if the sanding of the chamfer alone would change the geometry enough to affect the longevity of the...
No rod is straight I had them all machined while I had the block shaved and cylinders bored I nicked the chamfer surface trying to pull the cap...
I understand that! LolBut! However if the mating surface of the bearing to journal is perfect and just the chamfer was nicked and the burr was...
What is the worst that could happen if I just fled or sanded burrs off of surface and reinstalled?I had no "play" between #1 and 2 rods when...
Is it ok to sand the. Chamefer surface of a sbc piston rod if it has been nicked a few spots
Separate names with a comma.
The Jalopy Journal