The Jalopy Journal
Here is mine for the NYPD project: https://www.youtube.com/@abesKIA Haven't put up much content for over the last few months, but more coming. I...
Well after a gestation period of almost 9 months, my baby has arrived... back from the machine shop. This car was off the road since 1964, and...
Hi sorry for the late reply, had a death in the family and the car took the backseat. My choke housing, what is left of it appears to be exactly...
Hi Heathen, are you asking for the carter choke housing diameter?
I am bumping this thread from the way-back machine, it is a dilemma I will be soon facing. My '54 NYpD sat for 60 years, it has the Original...
heh. I have mess everywhere. Micky and Minnie found their way inside the bell housing LOL. [ATTACH]
Got it out. Thanks again to all. Didn't need to open the door. I Set the picker in at about a 45 degree angle, plucked it up and out. With the...
Thanks for the replies everyone... I think I am going to pull the two together. I put the car up on the dollies for maneuvering, it's not too...
yeah I was doing the math in the back of my mind, shop manual has full assembly at just under 1k, having removed manifolds, heads, generator,...
My shop is almost square, a foot wider than deep inside: 20x21, and the side from where I have taken the photo I have a work bench and cabinets...
Interesting. it gives good perspective. love the paneling in the shop!
Always good advice, thanks. I hate being under a car, getting old makes it worse ;) I was going to put a 4 post lift in, but thought I'd need it...
I'm leaning to do it this way. When doing the initial lift before disengage, should I loosen or remove the trans crossmember hardware?
I have a leveler, and yes I was going to pull the wheel just as you described. I might pull the back bumper off to give me an extra foot at the...
Separate names with a comma.
The Jalopy Journal