The Jalopy Journal
I'm humbled...thanks for the vote of confidence...to be mentioned in the same sentence as @CTaulbert ...wow! I'm extra humbled.
Thanks Sam...a classic case of over-thinking the problem. :rolleyes: For the next update, my axle bearings and 1/2" t-bolts arrived so I figured...
Get in, sit down, shut-up and hold on!
Building to a budget is traditional...not necessary to label it as a "rat". Cool car. Looking forward to watching it come together.
Thanks for the offer of measurements @Oneball ...the ship however has already left the dock on this one. That said, your photo showing the axle...
Thanks.
To close the bracket, and thanks all for your input and suggestions. @lostone and @Happydaze, I looked real hard at your suggestion(s). I could...
That might be some good thinking...I might need to look at that more closely. Thanks for your response.
Thanks ..there are no part numbers on the backing plates supplied by Q.P.
Thanks for looking. I just did a straight edge measurement from the axle flange to the inside of the shoe, and the same measurement on the drum....
Thanks Jim...my memory (good, but short!) forgot about that thread. :rolleyes: When I spoke to the guys at Quick Performance last week, I...
Here's a pic of the inside of the drum. There is a chamfer on the edge, but it's less than 1/8" deep, so the shoe should reside just at the edge,...
Separate names with a comma.
The Jalopy Journal