The Jalopy Journal
I dont think a vacuum will cut it. I draw about 28-29" vac
I used brass, that what the local plater had preferred but has since gone out of business. I would check with your plater before deciding on...
Looking good....still following along..
What metal was the emblem made out of? Copper??
Made a few of these for a local builder.... [IMG]
cant see your pics blowby....
Looking for some pictures of the various combustion chambers of aftermarket heads. Interested in the Evans (were they for flat top pistons?)...
[MEDIA]
<iframe width="854" height="480" src="https://www.youtube.com/embed/B62i7XeSPNg" frameborder="0" allowfullscreen></iframe>
Is the engine properly grounded?? Just a whim :)
That thread was a good read, thanks kiwi. Still leaves me the question what year were these produced, and in what quanity? Been researching Mr...
but is it rare?
ok, what can you guys tell me about this? [IMG]
Separate names with a comma.
The Jalopy Journal