The Jalopy Journal
Thanks everyone for your suggestions. As for clearances, all rods and mains were checked and were within specs. I don't remember the numbers...
Hello, I've got a 348 that I've rebuilt, new oil pump, and everything seems to be OK, except my oil pressure. To start I'm currently running...
Thanks Morris, After testing like you suggested, the gauge turned out to be bad. Swapped it out with one out of another dash.
Jim, What testing did you do to determine it was the gauge? Or did you just swap it out and it worked? Which is a viable troubleshooting practice....
Hey guys, Quick question, has anyone ever ran into an issue with their temp gauge after running a distributor that needs you to bypass the...
Thanks for all the suggestions guys, that's why I came here when I figured out I had this problem. The block has Pepsi sitting in 4 of the...
Thanks guys. I think next week I am going to bite the bullet and start with a brill bit and a good cold chisel. My brother dissolved an aluminum...
Hey everybody, I've run into something that I've not had to contend with before. I'm working on a '58 348 that I just pulled out of my Belair...
Thanks guys, I've sent Aubrey an e-mail to see if he has everything to accomplish this. I'd be interested to hear if anyone else has tried to do...
Mighty, I've signed up there and I'm waiting for them to allow me to post. Thanks for the suggestion though.
Hi everyone, I'm wanting to see if anyone can help me out with finding some specs for an engine I'm looking to build. I've got a 58 348 250 HP...
Separate names with a comma.
The Jalopy Journal