The Jalopy Journal
Here is a drawing of the ruler method for the three bolt distributor: [ATTACH]
Assuming you are running 12 volts with negative ground; the negative side of the coil(s) wires to the screw terminals on the center plate which is...
Nice job. A couple questions: On the left side of the drawing I assume the .8250 dim. is half the diameter of the valve head, and the .2699 is the...
A couple of pics for you:
Those look like Mate-N-Lok II connectors which I have used. They are nice because you don't need a special tool to remove the terminals if you...
[ATTACH] I made a quick drawing to check the crank to cylinder offset; the 1932 drawing looks right but the other one doesn't.
There is also this drawing from 1932:
[ATTACH] Here is a drawing I saved that was made by someone else so I can't vouch for its accuracy, but it would be a good place to start.
Are there dowels in the block that locate to the adapter?
Here is a link for you: http://oneilengineering.9f.com/photo.html
Check this thread for the drip tray; yours appears to be for a not roll down window. http://www.jalopyjournal.com/forum/showthread.php?t=638787
Package shelf:
Here's a pic of the pump rod bushing as used on 49 - 53 blocks showing the groove. Not sure if the hole in the block is straight sided or not but...
This thread has some ideas including mine in post no. 26. http://www.jalopyjournal.com/forum/showthread.php?t=449660
I used a 1 1/2" shaft length with a custom made bushing on the inside to get the length tuned for a close fit. Hand filed the aluminum stock...
Separate names with a comma.
The Jalopy Journal