The Jalopy Journal
For a mild street build without huge lift camshaft the stock style rockers will work just fine. I would go with a good polylock instead of the...
Water jackets don't look all that bad to me. Looks like the engine had steel shim head gaskets.
Several things with the vortecs are you have to buy an intake manifold specifically for them. You have to use center bolt valve covers or use the...
You can still do a good build with the stock pistons you have. Yeah the 624's are noted for cracking. The best bang for the buck street head are...
Prices at that machine shop are cheaper than I am, so I'd say pretty decent prices. I would also suggest the old Wolverine Blue Racer I think it...
If you're going to buy a set of aftermarket aluminum heads and are pretty much only going to be street driving it, I'd stay in the 180-190cc...
Like going to the beach sand intrudes everywhere. Being that it's going to be under high pressure I would almost guarantee it to get inside.
Yup I'm going. Decided to try and sell some stuff instead of trying to buy stuff with money I shouldn't spend.
283 cubic inch. Bored and Stroked 54 239. 1/8 overbore 312 crank.[ATTACH]
If you're set on using the electric fan wire the power to the fan and use the switch as a ground instead. Their are several wiring diagrams on the...
As above stick with the full roller rockers, and go with a good name brand. I've had troubles in the past with the cheap blue rockers from...
Can you find a place to re-babbitt the bearing shells? I have heard of this being done when people cannot find new replacement bearings for older...
Oil pump bypass spring? Oil galley crossover plug, but you'd have lifter noise if it was this. Lots of things it could be, but since you're going...
Separate names with a comma.
The Jalopy Journal