The Jalopy Journal
concidering this thread started over two and a half years ago is the car built? I do not know anything about elec. and am still learning about...
very cool truck,great details in build.very inspiring
bttt
ok checked,fuel filterits ok,pulled dizzy,how do u check bushing?I don't feel any side to side playin shaft,there is some play in up/down,also...
yea I will check into some of the above(compresion test,fuel filter,etc.)still not giving up or discouraged.... but I'm asking with dan above what...
ok,I adjusted valves,I reinstalled 6 volt coil as the msd blaster 2 coil got to hot(I'm assuming)and poped the top spewing what ever is inside...
thanks,that is what I was lookin 4...
thanks 4 info,I looked through link above found good info. but none with procedure of adjustment..but I think I'll give it a try.
believe this is orig motor for car,it has a 3 speed manual trans
found last rocker(closest to firewall)lose and adjuster backed out almost completly...hope this will fix,once I adjust valve that is...
I,ve did a search but did not find what I need.What is the procedure for valve adjustment on this motor? what do you set them at? Anyhelp would be...
notice my dist.is NOT turning when RPM's increase I am going to check when I get home today.hvychvy put new vac advanc on around 3 yrs ago but...
got a 54 inline 6 ran good when got it when driving saturday it started missing a little at first then it got bad I found rotor had chipped and...
Separate names with a comma.