The Jalopy Journal
In the time between my last post and now I have; built a shop behind my house, bought and sold about 20k lbs of machine shop equipment, started a...
Those look like nice machines. If it were me they would already be in the back of my truck.
1941 Buick sedanette for sale. Runs but needs the engine rebuilt. You can drive it around the yard if you would like. Straight eight engine,...
I think he is just welding the box and leaving the sector shaft intact and in stock form. If the box is cast steel then it's perfectly safe to...
I am indeed still working on the project. Unfortunately I don't have any real progress to share, work and my beautiful wife seem to keep getting...
Round here that would be at best a $50 engine block
You sure they don't measure 3.330? That would be .080" over.
Would a post '64 Mopar 8-3/4 bolt in? Assuming you had the right width of course.
You won't need to pre heat nearly that high if you are using silicon bronze. I think 200-300 would be just fine. I would plan on having to deck...
If you are any good with the Tig I would look into 308 rod or some silicon bronze filler. I find for better quality cast iron 308 rod works better...
[ATTACH]
Inlet, outlet, same thing when you are all doped up on hydrocodone. Just to be safe, I meant the lower one.
Squirrel, you have gotten my engine, (66 poly pictured above) confused with the op Budget36s' 1970s era 318. Mixup non withstanding your...
Yes my engine is a 66
Separate names with a comma.
The Jalopy Journal