The Jalopy Journal
When I rewired my '50 Ford I wanted 14 ga at the tail / signal light, and front park and signal bulbs. A friend of mine was rewiring a '49 Buick...
A thing of beauty.
I just used a large hole saw to cut an opening big enough to allow the pipes to go through and made the exhaust able to be separated in the rare...
Those look like GM wheel cylinder links. Ford links look like this.[ATTACH]
If you think the disc is stuck to the flywheel or pressure plate, put it in gear, step on the clutch and hit the starter. Make sure you're safe in...
Correct !!
Ford products in 1956 used 12 volt gauges.
Natures artwork.[ATTACH]
Pictures of some of my favorite cars here this week. Keep up the good work folks.
That's great news. A friend of mine has been waiting about a year and a half.
"So at what point will the reservoir that is never filled fail to be able to move the caliper pistons?" After everything is worn way beyond...
I very much agree with Oneball, Maybe a problem with PCV plumbing, is it original from Ford or an earlier engine converted from road draft to PCV?...
Here's one. https://vintagepartsofarizona.com/pete-and-jakes-3-bolt-to-2-bolt-master-cylinder-adapter/
There is / was an adapter that will allow a 1 inch Ford dual master cylinder to be bolted up.
The '50 Ford will go to full when the gauge sending unit wire is grounded; empty when just disconnected. If that much works properly it may be...
Separate names with a comma.
The Jalopy Journal