The Jalopy Journal
That car is beautiful. There is absolutely nothing to gain, IMO, by chopping the top.
Change all the ignition and charging goodies to 12v and install some solid state 6v regulators for your gauges. They're about a buck a piece....
Are alternators HAMB friendly? Anyway, I've got a reman delco 12SI alternator for one of my projects and i'm getting no output. It's hooked up...
I don't know crap about train sets, or sewing machines, but I would assume you'd have to beef up a sewing machine pedal to carry the current....
Chassis Engineering and Walton Fab makes motor mounts. If you use stock type manifolds, you'll need one center dump and one rear dump. Sanderson...
After being stranded multiple times due to Dodge truck amp gauges, I have a phobia of them and replace them with voltmeters in anything I drive.
The heads are an issue on the 305's. They don't flow much and if you replace them, you'll probably end up lowering the already low compression...
Make sure the proper bolts are in the holes also. And use the proper sealer on bolts that go into the water passages.
Practically new shortblock, has been sitting an a garage. There is some slight rust forming on the cylinder walls. Not pitting or anything, just...
Gospel I've bought some of the cheapo welding clamp pliers and some of the cheap 4 1/2" grinders and a bag of the EXACT same panel holders that...
The clutch essentially pivots on the master cylinder mounting doo-dad, so yeah, it's different. I think National Chevy sells them, but I imagine...
On the same day I bought an aluminum carb adapter plate to put a rebuilt Edlebrock 4bbl on my stock intake(i saved for months to buy the carb), i...
Get a good one and mount it properly near the tank. keep a spare in the trunk. That probably good advice for those running mechanical pumps too.
Separate names with a comma.
The Jalopy Journal