The Jalopy Journal
Bump
FOR SALE Traditional-styled ’36 Five Window built on exceptionally nice 32K mile original. Dropped axle, new springs, shocks, sway bar. Rebuilt,...
15 inch Big 'n Little Wide Whites for your Hot Rod, Custom or Low Rider: Two 810-15 and two 560-15 Deluxe "Gum-Dipped" Firestone Bias-Plys. Very...
This popped up on the internet recently. Custom one-off? PhotoShop? Ford design exercise? Or an Uber-rare actual model? I’ve never seen one. [ATTACH]
Finished and now on the road...[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
No, can't do it, the tabs are cast into the glass -- and it would take some considerable reshaping. My incandescents are 6V.... and you're...
Are you running Halogen sealed-beams in your B-L-C buckets? What brand? I pulled the original 12V sealed beams out of my B-L-C 682-J headlight...
Are your headlights running thru relays? Or pulling direct current thru the switch to the bulbs? Did you recently switch to halogens?
Ram 401 pressure plate, Ram 212 clutch disk and stock Ford throwout bearing. The longer clevis gave me the additional travel I needed to reach...
All done and dialed in. Thanks for all the response. Now to put some miles on ‘er.
I looked this up in my Green Bible and Ford used the same 78-7580-A Throw-Out Bearing from 1928 to 1948.... are these Ford bearings you're...
Here are photos of the Ram pressure plate and clutch disk. Is this a “high crown” or “low crown?” Yes, I surfaced the flywheel before assembling...
Separate names with a comma.
The Jalopy Journal
Post
