The Jalopy Journal
Haha I figure they're still making carbs and not making hemi speed parts so carbs should be belly button cheap?!
It lost almost 1/2 second compared to the injection. Jimmy loaned me some better carbs to try out. Haven't tried them yet though. Race carbs can...
I just got tired of always messing with the injection. It would change the idle RPM as the engine heated up. So after a burnout it would be at...
Yeah there was a bunch of stuff that needed attention. I ended up putting in a new set of Molnar rods and getting the crank turned. @402BOSSMAN...
I had an issue at the November finals where the fuel pump over ran the floats and hydraulic-ed the engine. Broke 2 rocker arms so by Ringold the...
Haha I still remember that! Thanks a lot man!
I think the wheelie bars are still too low. It didn't feel like it pulled the wheels at all. [ATTACH] [ATTACH] [ATTACH]
The tunnel ram is slower than the injection - but a dyno session may show the carbs are not tuned yet. It's just so easy to start and drive with...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Wow! A year and a half ...... lets see, that B/G engine killed the rod bearings because it only ran above 8,000 rpm. The oil is either foaming at...
You care if I post that shot on my build thread Tom? I'm going to put some stuff up on my old thread. Its just been a tough 12 months around the...
I wish that car was for sale. Very competitive car.
Finished example! [ATTACH] [ATTACH] [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Nice rust free panel truck. It has the original engine and trans but you wouldn't go very fast with it. I drove it into the shop 2 years ago but...
Separate names with a comma.
The Jalopy Journal