The Jalopy Journal
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] Part Number SB1625-1 (Valve Seats) Specifications Type Data Angle 45...
all of the seat i have done the cutter was a common size 1.5 1.625 1.687 ect and the seats had the press built into them. for your 1.625 bore the...
Newer than 1965 but thats only a guess
I moved the 350 in my 50 chevy truck 1 1/4 to clear and never noticed
pull it apart and weld it up looks to me like some cut a bushing out wit a torch and burnt through. you might have to grind it bigger to weld it...
I would have to reread his post again but i believe he added a hole for clutch adjustment and that was where it failed
The wire is to energize the altenator as soon as you turn the key with out it it has to spinn fast enough to energize its self. If you car starts...
was a common failure on hei distridutors when the wires from the pickup to the modual
EFI is not shown here and what updated suspension most independants will not be welcome. Looks like you have a cool project if the efi is the only...
The blocks i have seen bushed on 1 side had a 0.030 oil feed hole drilled to feed a solid roller setup. Are the bushings honed to size because...
Looks like b&m is part of holley now call there tech they are good but you might be on hold for a while 1-866-464-6553
https://www.jalopyjournal.com/forum/threads/hemi-dodge-truck-bell-housing-flywheel-linkage-dust-cover-etc.1210546/ If you are looking for a stick...
the truck bell works with the smallblock tranmission length. the fe car trans used a shorter input shaft.
Separate names with a comma.
The Jalopy Journal