The Jalopy Journal
I’m reading SPI will fill 180 scratches. I might just have to finish off with more epoxy. Thanks.
Sorry I shouldn’t say I need something that builds I just need a primer that will fill the 180 scratches. I should mention that although the...
Hey metlmuncher I actually used SPI epoxy onto the bare metal prior to bodywork and highbuild. I agree it is nice stuff and sands decent, but...
thanks for the reply K13. I have actually read the TDS sheets for both products and you’re right I didn’t fully follow the instructions for FF....
Whoa! Thanks for all the replies and valuable info. Sorry for not checking back sooner. I ended up disassembling the truck (1964 c10) for final...
Rather than start a new thread I figured I’d add a question to this one. I have done 2 rounds of featherfill with guidecoat and have my truck...
Could the valve tip/rocker arm angle been off enough to put lateral force on the valve stem? Maybe the guide wasn't installed properly? Just...
Thanks! ss34coupe, Most of its pretty rusty but i'll see what I can do! ha!
23 posts and just realized I never did an intro. I'm 30 y/o and have always been into old vehicles. My daily driver is a 1964 c10 and I put...
Nice truck! You got a hell of a good deal. I paid the same for my swb '64 and the front fenders and floor boards are toast. Been driving it daily...
Yup bigger is better for power brakes, but not for manual. You'll want to stay with a 1" bore MC or less for manual brakes so the 15/16 will be...
Yeah no problem, I just went through the same thing with a 327 i'm working on. Hope those gaskets don't leak, they aren't cheap!
[IMG] This picture should clear up any confusion, just lay a straight edge across the pan and measure the depth of the "half moon". 2 3/8"...
Don't want to start another thread on this, but after reading this one, i'm still confused. Is it okay to run a disc/drum MC on a drum/drum car?...
Separate names with a comma.
The Jalopy Journal