The Jalopy Journal
Hey all, as the title says, a 3200 lb vehicle with 140 hp and a 3 speed with 3.08:1 rear and 28 in tires... is that enough power to get around in...
Hey all, Forget coker classic and specialty tires, dont want to spend that or use bias ply. I am looking for the tallest skinniest radial for a...
Hey all I hope this isn't ainti-hamb but here goes: I am going to build a car. I was pretty determined to use an A roadster body, but considered...
Hey all! I've decided (95%) that i'll be going with standard 2500lb airbags first in the front and then in there rear when the gas tank is out...
Hey all, I know a 90° can be curved easily with a shrinker stretcher, but how about a compound series of 90° like this dogleg? A single dude in a...
Howdy all, Something in my gut is telling me not do paint my new aluminum radiator black with rostoleum grill paint. That it it could inhibit...
Hey guys, quick question: I can think of about half a dozen ways to bend the ridges/ribs required to make a floorboard into a piece of sheet...
So I put a gauge from autozone on the motor and Turned the oil pump with a drill. While the drill wasn't anywhere near full speed because of the...
Hi all In the fall of 2013, at a service garage near my house, I noticed a 1950 Chevy. It was far from the road but stood out in bright green....
Hello, I had planned to make my exhaust, or at least most of it, with lengths of 2" straight pipe and u bends. Planned to expand the ends and...
Howdy, Just grabbed a th350. Have a few questions. 1) the dipstic tube is loose fitting into the assembly and I assume missing a grommet of...
Separate names with a comma.