The Jalopy Journal
Thanks those look more like it. I will mic these and my take offs as to ensue they will fit. Thank you
I purchased the RW207 bearings for the rear end described in this thread. It was thicker than the original ones on my shafts. I installed them...
Is the RW207 the bearing number I can goto my local auto parts store and find them. I have the same rear end in my 1954 Ford. Does anyone have a...
Thank you. I knew that someone here would have the answer to my question. I thought the frame was the same I think up till 57 or 58. I...
I am ready to take my car to the alignment shop but they don't have specs for the alignment for my 1954 Ford Mainline 2 door sedan Hot Rod. I...
I have an Airbagit system What city is the shop in for look up or PM me Found it, love google maps
I don't post a lot but I read a lot here on the Hamb. I have a 54 Ford Mainline that is now a 90% complete custom in the period body...
Love the car. I think the 52-54 Fords are under appreciated. I have a 54 Ford that I will post here. Almost done and it has been a long haul....
Wow love it, nice work with the rear section of the roof.
Unfortunally not the smoking gun I was looking for but I will go back thru the math and figure it out. I believe it will work Nothing is easy...
11/16 master and 13/16 slave figures to be about the same as the 3/4 master and 7/8 slave if you convert the fraction to decimal. That is how I...
Thanks for the braded line fix for one small problem I noticed already. I should clarify that I purchased the 1988 WC T-5 from Jeggs as an I...
Does anyone know where to find the throw. The master and salve are matched from the doner vehicle that had an t-5 in it. I am hoping these will...
Separate names with a comma.
The Jalopy Journal