The Jalopy Journal
I ran a scott topped 97 on my speedster. I used foam cut from a microphone wind screen and it worked fine. You need something to stop the water...
Bangers, FNG here. I have a rattle in my engine that I suspect is a loose rod. When I listen to the engine with my dowel rod, the noise...
Is there a bearing at any point on the dist shaft?
Fellow HAMBERS, I am running a Mallory series 23 single point dist on my 31 4 banger. Last week the dist froze up and when I pulled it there was...
Gents, I have a Model A 31 block bored .100 over, Stromberg 97, Ansen intake, tube headers, Mallory 23 cent /advance dist. set at 8 degrees in...
Hello Fellow Bangers, Spring is finally here and the newest version of the speedster is up and running. Had a casting break on the original water...
Brent, Great website! I noticed that in your racing "A"'s the cowl is well back from the original. I assume this involves moving the steering...
I did a stupid thing last week. I tried to replace jets with the carb on the car and ended up striping out the plug threads on one side. I managed...
Mac, I'm building a speedster but am having problems getting a boat tail. looks like the one on Carls S car came in four pieces. Perhaps I could...
30 to 45 seconds then pfft.
H.A.M.B.ers, Ok, I woke up Uncle Max's wife, and got his great nylon washers. The leak between the carb body and the adjustable jets is...
Separate names with a comma.
The Jalopy Journal