The Jalopy Journal
Time to dig in and get the van ready for the vintiques nw nationals.
Welcome to the hamb from the vanman!
Welcome good luck with the falcon trim i have never seen any for sale.
It will sound like six with glasspack mufflers. A single would sound better than duals. It wil be loud and raspy might pop and backfire on...
Also you will have to use the 144 / 170 clutch disk and the 200 pressure plate. I made a pilot bearing on a lathe Out of oilite bronze bearing...
Actually you might have to change the bell housing they changed the bolt pattern in 68. Also you will have to weld some ears on the trans so the...
Keep the 200. Zero deck the block thats .060 off the top on the 200 to raise compression. Install a dura spark II distributor. Go with the webber...
as far as I know the pop out the window weatherstripping is obsolete. you have to use a universal ype weather stripping. try JC Whitney for your...
Where are the pics of this beast?
I have a 61 pickup with 90xxx for sale little rust needs engine and trans. make offer! Need it gone
Welcome from the great northwest. Hope you enjoy the van.
welcome check out the econoline madness thread and post some pics if u havnt already
ok looks like a pretty simple design. but how well does the floor hold up to the torq of the v8? should i maybe extend mine to the subframe rails...
Im pretty sure all econolines 61-65/66 were the short model it was the later versions 66 thru 68 that had the extended rear end.
Separate names with a comma.
The Jalopy Journal