The Jalopy Journal
[ATTACH] [ATTACH] [ATTACH] I'll play. My 1948 F3. Channeled 4.5 inches, zee'd rear frame and notched frame for the front axle to get it down....
Count me in. Busted ass all winter to get my truck done in time for it but I don't think I'll quite get it done (ish enough).
Looking forward to it!
A2B, nice work. Im not understanding your vacuum source though as exhaust would be positive pressure not negative.
I went back and you are correct. Two of them were 52" and one was 52.5". I must have missed it the first time through.
This is a great point, and it would probably chew up the tail shaft bushing. Might just need a slightly shorter driveshaft. Wonder if all three...
One of my favorite threads. Any updates?
Looks fake to me. Rear door?
I had a long winded reply typed out but after re-reading this whole thread I think everything I could think of has already been mentioned . Is...
IF you really want to run an enclosed drive AND you understand that it entails more than simply buying the trans then it may be worth the money...
I always try to stick with whatever the product recommendations are. With the exception that I always at least lightly sand between primer and...
I took out a good sam membership several years ago primarily so the wife and kids would have something. We never used it so I was just about...
Need to finish the wiring, build a set of running boards, wood floor in the box, address some minor front suspension stuff, finish the interior,...
What causes metal to shrink over time like that?
[ATTACH] I believe you are correct in some cases. I seem to remember reading that the "early" T4's maybe didn't have the bump. Mine did have the...
Separate names with a comma.
The Jalopy Journal