The Jalopy Journal
I have a Sids 5 inch drop axle, reversed main leaf and I removed a few leaves. Unsplit bones. I'm also running the chassis engineering dropped...
Yep I bought my clutch in my A sedan from Fort Wayne. Quality is absolutely top notch.
Here.[ATTACH]
I'm pretty sure there is a mercury pressure plate that bolts up to the chev flywheel then use a ford disk
I have to spare FEs hahahahaha! Hopefully that's enough! You've rode with me in my A sedan....
I've never been known for driving like an adult much but I'm hoping the firestone bias ply lack of traction will help with that!
In high school and hadn't even heard of the hamb at the time. But was driving my chopped shoebox daily. [ATTACH]
I've ran 4 inch no taper blocks on a shoebox in the past and had no vibration issues. When going over large whoops the u joint would hit its angle...
I don't remember seeing it. I'm sure i was there at the show. The offset carbs make me think it was a 6 cylinder engine. I bet Jimmy Flowers would...
Well I was able to take a sanding drum on my die grinder and slowly open the bearing and lock collar up till it was a tap on press fit. I went...
I remember drooling over the Coca-Cola Cowboy in Rolls and Pleats when I was in high-school.
I have an extra bushing that goes at the top of the column. It's a bronze bushing in a rubber sleeve. I used sand paper to open it up to a nice...
Delrin is a good idea. The header is pretty close to the column where the bearing is needed i wonder what heat delrin can withstand.
Digital caliper. The outside diameter needs to be 1.375 for the Shoebox coulmn. I've looked at most online supply shops and can't come up with one.
I'm trying to get my steering set up on my shoebox but can't find a support bearing for the end of my column. Everything i read says my steering...
Separate names with a comma.
The Jalopy Journal