The Jalopy Journal
[MEDIA]
[IMG] This is about 30 years old. Today's stuff is exponentially more complex.
BTT
PM Sent
Yep, looks like I mathed my math wrong and it should have been 0.040" off the top, much more feasible than 0.070". I corrected my previous post....
The value is in the core, not in the scrap. That said, scrap cast iron typically goes for $100 to $150 per ton. I would offer him a couple of...
302GMC is spot on. Yes they can be re-sharpened. The challenge is resharpening them without affecting the cutting geometry.
How is your fluid level?
Just because this is the HAMB, I understand forced induction helps in these matters quite a bit..... We ran a fleet of 454 powered Duallies at a...
Pickup truck, or Truck Truck??? I have one of each, though the '51 is currently disassembled. [img] 1960 Ford C700 (and my next project...) [img]
You guys have fun. I am not going to make it again this year. No good excuse except simply too much work to get done right now and I can't...
This is the bare minimum rig that you will need to find. My 1960 Ford C700 on a 20,000 lb rated flatbed gooseneck trailer. It was everything my...
Separate names with a comma.
The Jalopy Journal