The Jalopy Journal
Another plug for a&a had issues with tci with several units,gm and chrysler
If you don't see what you need on line ,call tec,they recommended springs they don't list on line more than once for me.so call them,there pretty...
Flat tappet solid needs 135-140 on the seat and try to stay under 400 over the nose. Most of the heads as you discribed use pressures in this...
What oil,and is it a hi volume pump. I normally see 65 psi during a prime with a std volume pump. 10-40 or 15-50 break in oil.goes to 40 psi hot...
If the hole in the factory gear is too small,reem or hone it to fit. I have done this quite a bit. Any competent engine builder should have the...
I use a mitatoyo split bore guage it will read the bore of the guide as you pass through it,a air guage is fixed to a table or stand,really can't...
On the intakes I run .0014-.0015 ,exhausts .0017-.0018 except for the two siameed exhaust ports I run them at .0020 . A proper bore gauge ,split...
.045 and .060is just fine,most of my street and hot street work is in that range. No one mentioned valve guides. If the guide is straight and...
That was done by a outside shop,judging by the job it looks very well done. I would have to see it with a intake and a ex removed to really tell...
If it passes a pressure test,I would clean it up and run it. It's a early 2piece rear main,if it still is the 3.48 stroke you will be fine. The...
What are the chances,didn't even notice. Now that's funny shit right there.
Ballancing can get a little complex, I have the equipment and do it regularly . With the new age of affordable electronics it is easier and more...
I haven't been here for a while and this thread has many reasons why. Wen I first came here I was in the same sand box with some very talented...
crazy the replies on here, I take welding very seriously. Been a tig welder for 30 plus years and my daughter who I taught at 12 is a welding...
I get 40.00 to hone a set of bushings,ship it to me and have it back within the week. I have offered this before to other hambers but very few go...
Separate names with a comma.
The Jalopy Journal