The Jalopy Journal
Old Safety Racing magnesium wide 5?
A friend of mine uses the Bert sprint car setup in his silver crown car. It works well and might be the best solution for the OP since it has low...
The layout is pretty similar to how Bill Hite built 4WD, mid-engine supermodifieds in the 70's. Engine in car backwards, transfer case toward the...
Not yet, but I think the post above about permit mail taking a long time is accurate. Even when things were normal at TRJ, it would take 3-4 weeks...
I agree with this. Camloc's were introduced in 1937 and the patent applied for in 1941. I'm thinking the ones in the photo might actually be...
The steel Hilborn stacks that I've owned were zinc plated, so using the galvanized 0.035" wall stuff would be pretty similar to the originals I had.
One way to do it if you have access to the back of the panel is to use flush solid rivets, with the head countersunk into the back side of your...
I've gotten my last couple batches from these guys: https://www.s-sengineering.com/ They manufacture the weld-on plates and dimpling tools....
This makes me happy. Ryan always builds killer stuff!
This stuff is very flexible, McMaster calls it "machine tool wire": https://www.mcmaster.com/wire/wire-and-cable/machine-tool-wire/ They also...
I do header flanges the same way as Marty...TIG weld the inside and silicon bronze on the outside. It helps prevent burning through the pipe when...
This. The power steering hose is different and rated for much higher pressure than the braided AN hose. It usually has a braided nylon outer cover...
I have a bar on either side of my welding table to hang mine on... [ATTACH]
I have one of the Furick bead rollers from an early run of them. I think he's done some improvements since then...it does what it's supposed to,...
Definitely this. I'm not working on anything HAMB friendly right now, but it's hard enough to find the time to actually work on stuff, let alone...
Separate names with a comma.