The Jalopy Journal
I put my rear drums on the axles and turn them together.
Can you share how you made your hose clamps?
I left a voice mail at Williamson's 2 weeks ago still no response? Ron please check your messages.
You can TIG weld that broken spacer to the backing plate. I don't use and filler rod just run the puddle all the way around on both sides. Makes...
I'm using the same kit on my project Coupe. Tack everything and make sure your trunk lid fits before you weld it.
DA is short for dual action it's a sander that spins and orbits.
Onekoolkat1950 can you share how you made the knob?
Line up the glass channel. The glass will not bend. You will need long slices to repair the misalignment. I can see a slice 4 inches above and 2...
Thank you Larry for saving this beautiful Hot Rod.
You got, it the picture you drew looks great can't wait to see it in steel.
If you were to use the water pumps that most builders use. The hole in the water pumps for the motor mount biscuit are 20 inches on center. The...
I just measured my 47 flathead with truck water pumps. The motor mount with is 20 inches on center. Your drawling looks great but, your unfinished...
Great job. I make all my threaded adapters from a solid 40 ford driveshaft.
Separate names with a comma.
The Jalopy Journal